When the mower leaves the factory, the engine and all running parts have not been fully running-in. Because the running parts still have processing traces. If it is used without running in, the friction surface will be severely worn and the service life of the engine and other parts will be shortened.
Fill the lawnmower with oil and gasoline before running in. Tighten each fixed part to ensure good technical condition. Start the engine and make the engine run at low speed for 10 minutes, increase the throttle and run again for 10 minutes, and then make the engine run at high speed for 10 minutes, reduce the engine speed and engage the cutter, and gradually reach high speed for 30 minutes from medium speed. Complete the early run-in.
Machine running-in work should be combined with trial cutting together, in the completion of the early running-in, the lawn mower should be fully checked and adjusted before trial cutting.